60V 100A 20S 20x 3.2V LiFePo4 Battery BMS LFP PCB PCM SMT System [60V 20S 100A LiFePO4 LFP BMS] - $80.00 : Lithium Rechargeable Batteries, Battery BMS, Pack Assembling

Categories

Products description
Reviews
Reviews write
Shipping
Privacy Policy
Contact us

60V 64V 100A 20S LiFePo4 Battery Pack BMS for E-bike

20S 100A lithium LiFePO4 Battery protection board.

Technical Parameters:

Balanced current: 60mA (VCELL = 3.90V when)

Balanced for: 3.50 ± 0.05 V

Over-charged Protection: 3.85 ± 0.05 V

Over-discharged Protection: 2.1 ± 0.05 V

Over-charged delay: 1 ± 0.5S

Over-charged release: 3.80 ± 0.05 V

Over-discharged threshold: 2.10 ± 0.05 S

Over-discharged delay: 100 ± 50mS

Over-current Protecton: 100 A

Supports Max. Continuing Discharge Current: 100A

Static power consumption: less than 200uA

Short-circuit protection function: disconnect the load from the recovery.

Dimension: 182mm * 85mm *40mm

Feature: With Aluminum Protected Outer Shell and built-in Radiating board

The main functions: Over-charged, Over-discharged protection, short circuit protection, over-current protection, with Balancing function.

Interface Definition: The board have balancing function. So you may see a balance connector with 20 wires, when you do the connection for the 20S batteries, start from the first Red wire, then connect other Grey wires one by one, dont make wrong orderly as this will get the BMS burnt, check battery voltage step by step, it start from 3.2V and increases with (3.2V~3.6V) one by one to make 60V (64V) finally. Check every voltage increase with below parameter:

3V - 6V - 9V - 12V - 15V - 18V - 21V - 24V - 27V - 30V - 33V - 36V - 39V - 42V - 45V - 48V - 51V - 54V - 57V - 60V

The 2 thick Black wires connect to battery pack Negative, and 2 thick Yellow wires for Motor / Controller ( Discharge) Negative, and 1 thin Yellow wire for charger Negative.

Charge & Discharge Positive could be the same output.

The BMS only works for Brand new good quality battery with perfect performance, it cant work for fake capacity and used batteries.

Check every voltage on the wire step by step before plug in the connector. Check every wire and see if the orderly are correct. Because if any of the wire get a wrong order, it will get burnt. Smoke shows board already get burnt for protecting the battery being damaged by wrong connection, For DIY assembling. Please make sure you are capable to do the assembling before ordering! If you dont know how to do the connection, DONT ORDER IT!

IMPORTANT!!!

The BMS only use for new and consistent high drain batteries.
Do not use for battery packs that mix with new & half-used, or mix with different brand battery cells.
Do not use for used and imbalance battery cells.
Do not use for batteries with fake capacity.
Do not touch the board by hand while it is charging / discharging.
If you charge the battery by LiFePO4 Balance Charger, then there's no need to use BMS.

Battery not including, the auction is for BMS only.

Balance Connector will send together with the BMS.

You may also check with charger info. from our online Categories:

Categories - Battery Chargers - LiFePO4 eBike Charger - 73V 5A LiFePO4 Charger

Wholesale Welcome!

Shipping:

Items will be shipped out in 24-48 hours (excluding weekend or holidays).
We will ship with the delivery address according to your Paypal payment,please be sure your shipping address is correct
when you pay.
Small packages less than 2kg will ship by registered mail service, most of the areas normally take about 14-20 days to
deliver.
Some countries may take over 30 days to deliver, you may refer to " F.A.Q" page, " Shipping & Delivery" for further info.
We also offer optional UPS / TNT / Fedex Express service with higher freight cost but fast delivery.
Lithium Battery with strict restriction for air shipping. For parcel under 2KG, it could ship by HK SAL Sea Transportation (Zone Rates)
with low cost but shipment would be very slow.
If you can't wait for long delivery for battery products, there's optional Expedited Shipping (TNT / UPS / Fedex) for
selection.
All the shipments will have a tracking number to trace with.

If you do not receive the package over 50 days, please contact us, we will check with the shipping status for you.
Items will be labeled as Gift or Toy Components with under invoicing to avoid import tax. In most of the case,
package will not have any import tax and or handling charges, if any custom tariff duties, buyers will be
responsible to pay the import tax.